Model 91 Bay Heater Fireplace Insert & Freestanding FEATURES PREPARATION INSTALLATION OPERATION MAINTENANCE SAFETY Contact yo
REQUIRED FIREPLACE DIMENSIONS Minimum fireplace dimensions: Height Width Depth
POSITIONING THE HEATER When positioning the heater, the following conditions MUST be met! (See Figure 2.) 1. The front of the damper opening must b
7. Slide the unit back into the fireplace. Check to be sure that the trim panels are properly positioned and lie flat against the front of the firep
SECTION III RESIDENTIAL FREESTANDING ROOM HEATER INSTALLATION INSTALLATION PRECAUTION Extensive field and laboratory testing h
MODEL 91 BAY MINIMUM CLEARANCES The New Buck Corporation Model 91 Bay must be installed in compliance with the instructions contained in this manual
PREPARING THE STOVE FOR INSTALLATION 1. Inspect the unit for any obvious physical damage. 2. Plug the power cord into a 115V AC outlet. Set switch t
CLOSE CLEARANCE INSTALLATIONS (in inches) Close clearance installation is possible by using the following brands of black, double-wall chimney pipe. (
thimble meets the NFPA-211 Code and local building codes and is a minimum of 18" from the ceiling. If the connector thimble does not meet these
Example: The rear clearance for the Model 91 from page 12 is 18". (See Figure 1.) This clearance may be reduced by 50% to 9" by using eith
Tested and Listed Wall Protector Clearances to combustibles may be reduced if a tested and listed wall protector is installed over a combustible sur
TABLE OF CONTENTS SECTION I Room Heater Features...
SECTION IV WOOD HEATER SAFETY Certain safety hazards are inherent in any wood heater installation. You should be aware of these so that a safe and
SECTION V OPERATION This section of the manual is to help you get maximum efficiency and maximum smoke (particulate) reduction from your heater. If
BUILDING A FIRE: 1. Place the “Manual/Off/Automatic” switch in the “Automatic” (bottom) position for thermostat control operation. Turn rheostat kn
SECTION VI PREVENTIVE MAINTENANCE / PARTS REPLACEMENT THE CATALYSTS The catalysts in your stove are designed for many years of use. If after severa
8. Cleaning the catalyst with plain water can reduce build-up of the catalyst-retarding chemicals. Nothing but a soft brush, low pressure air or pla
MOTOR ASSEMBLY REPLACEMENT (Motor, Thermostat, Rheostat, Wiring Harness) 1. Unplug the heater from the 115V AC outlet. 2. To replace the motor y
OFF AUTO/MAIN SWITCH WIRING SCHEMATIC
SECTION VII TROUBLESHOOTING Operation of any wood heater can create problems. While the use of a catalytic-combustor equipped stove will substantia
3. Backpuffing 4. Smoke Rollout when Heater Door is Opened 5. Low Catalytic Temperature COMBUSTOR-RELATED PROBLEMS 1. Plugging
NEW BUCK CORPORATION (NBC) “LIMITED WARRANTY” FOR NBC RELATED PRODUCTS PLEASE READ THIS WARRANTY CAREFULLY PRODUCTS COVERED This warranty covers
SECTION I The New Buck Corporation room heater Model 91 Bay is one of the safest and most efficient heating systems available when installed and opera
EPA COMPLIANCE STATUS This manual describes the installation and operation of the New Buck Corporation Model 91 Bay wood heater. These heaters meet t
CATALYST EQUIPPED This wood heater contains a catalytic combustor, which needs periodic inspection and replacement for proper operation. It is agains
CATALYST MONITORING It is important to periodically monitor the operation of the catalytic combustor to ensure that it is functioning properly, and t
SECTION II MASONRY INSERT INSTALLATION INSTALLATION OPTIONS This unit (appliance) may be installed into an all masonry fireplace, built in accordance
FIGURE 1 FIREPLACE INSERT 30" 20" 15" 20" 8" 24" HEARTH EXTENSION MANTEL INSTALLATION (Fire
Comments to this Manuals